User Manual

9.0 LABELING REQUIREMENTS
The FCC requires that the Part 15 statement be installed on the outside of
the final product in a manner which allows it to be seen and read. The
accepted statement and a sample label format are as follows:
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following
two conditions:
1. This device may not cause harmful
interference, and
2. This device must accept any
interference received, including
interference that may cause undesired
operation.
Contains FCC ID: JHIGNET
IC: 4840A-GNET
MODEL: XXXXXX
Graco Inc.
P.O. Box 1441
Minneapolis, MN
55440, U.S.A.
The label should be printed or molded into the case using a type front and
size that is readable with the unaided eye. The FCC identification number is
required.
10.0 RF EXPOSURE
This module has been designed to comply with FCC RF exposure
requirements outlined in Parts 2.1091, 2.1093, and 15.247(b)(4). Deviation
from the recommended installation may violate RF exposure requirements.
The Graco GNET RF Transceiver Module is limited in application to products
“generally used in such a way that a separation distance of at least 20
centimeters is normally maintained between the transmitter’s radiating
structure(s) and the body of the user and nearby persons.”