Specification

63
Light Gauge Metal (20-25)
Product #210
Scavenger
®
Head Fastener (1 OF 2)
APPLICATIONS
 1/2” to 5/8” single-layer gypsum board to 20 – 25 gauge steel studs
and runners
 1/2” and 5/8” double-layer gypsum boards to 20 –
 25 gauge steel studs, runners, furring, and Z furring channels
 1” coreboard to metal angle runners in solid partition
SPECIFICATIONS
 Gauge – #6
 Lengths – 1” to 1-5/8”
 Head Type – SCAVENGER
®
 Recess Type – #2 Phillips
 Thread Type – Double Lead
 Finish – Gray Phosphate
 GRABBER
®
screws are manufactured in an ISO 9002 and ISO 14001
certified and approved factory, and are approved by ICCES report ER-5280.
PRODUCT FEATURES
 Unique head configuration helps eliminate paper burrs and aids proper
seating of fasteners A fine thread screw for general interior applications 15
threads per inch
 Super sharp, 23° STREAKER
®
point, designed to penetrate steel quickly and
easily
 #2 Phillips recess drive
INSTALLATION GUIDELINES
 Use a standard screwgun with a depth-sensitive nose piece. Suggested
screwgun specification for optimal performance – 4 amps minimum and
RPM range of 0 to 4,000.
 The SCAVENGER
®
head is fully seated when the head is flush with the
work surface.
 Overdriving may result in failure of fastener or strip out of the work surface.
 The fastener must penetrate beyond the metal three full thread pitches.
Attaches gypsum board to 25-20 ga. steel. Unique Scavenger® head helps reduce
paper burrs.
Finish - Black/Gray Phosphate