User Manual

P. 3
SET UP
1. TRANSMITTER
1. Connect the AC power adaptor included with your unit to electrical wall outlet.
2. Plug the AC power adaptor included with your unit in the jack located on the rear of
the transmitter. Option 4 X “AA” size ALKALINE batteries can be used to power the
transmitter for portability. NOTE: ensure battery polarity (+/-) are matched and correctly
aligned correct when inserting the batteries in the compartment
3. Turn on the transmitter by setting the POWER switch to the ON position, and the
POWER LED (blue) on transmitter will start flashing.
4. The retractable audio cord located at the front of transmitter can be connected to an
audio output jack of any audio source (i-Pod, i-Phone, MP3, Hi-Fi, MP3/CD/VCD/DVD
players, etc.)
RECOMMENDATION: for best audio, set the audio device volume to 50-75% of
maximum output
5. When the transmitter receives an audio signal, the blue SIGNAL LED and the red
POWER LED will illuminate together. If the blue SIGNAL LED does not illuminate,
ensure the audio source is turned on and properly connected to the jack.
2. SPEAKER (RECEIVER)