Quick Start USER GUIDE ECOXBT Models: GDI-EGBT500-510 Features & Operation ECOXBT Control Buttons LED Status Indicators: POWER, BATTERY, Bluetooth Diagram 1 Contol Buttons & LED’s ON/OFF Bluetooth SPEAKER VOLUME TRACK SELECTION PLAY / PAUSE / ANSWER BATTERY INDICATOR
How to pair your Smartphone with your ECOXBT ON/OFF PRESS button once to Power ON / OFF Bluetooth STEP 1. Find & enable Bluetooth on your Smartphone/ SmartDevice Green LED turns STEP 2. PRESS button ON & unit once on ECOXBT to beeps within initiate Bluetooth. 2-4 seconds BLUE LED will blink indicating rapidly indicating ready power fully to pair. initiated and set ON STEP 3. Find “ECOXGEAR” on your Smartphone as a pairing selection & select “ECOXGEAR” to pair with ECOXBT STEP 4.
Quick Start USER GUIDE USB & AUX-IN CONNECTIONS CAP, USB POWER & AUX-IN CONNECTIONS Pull tab on the cap to open the back panel compartment for access to AUX-IN & USB CHARGING connections AUX-IN can be used as an optional connection to play an audio device using a 3.5mm audio cable connection.
Quick Start USER GUIDE BACK PANEL & CAP Diagram 3.1. Diagram 3.2. back panel cap line gray rubber cap gasket IMPORTANT: IF the cap is not securely closed the unit is NOT watertight & waterproof. To ensure the unit is watertight, the back panel CAP MUST be closed securely. To securely close the back panel CAP, the CAP MUST be inserted so that the lines on the CAP align with the back panel lines and the top of the CAP is pushed flush with the back surface of the unit .
Quick Start USER GUIDE TIP: Bluetooth PAIRING once paired, should you wish to connect to an alternate device, open the Bluetooth Section within Gracedigital the device currently connected to the ECOXBT and remove the Bluetooth connection. The ECOXBT will then be available to pair & connect to an alternate Bluetooth enabled Smartphone / Audio Device FRONT PANEL Diagram 4.1 SIDE PANEL Diagram 4.2.
Quick Start USER GUIDE FCC Compliance Statement & Warning: This device has been tested & found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. The device generates, uses & can radiate radio frequency energy & if not installed & used in accordance with instructions may cause harmful interference to radio communications.
Quick Start USER GUIDE 8. Periodically clean the rubber with a soft moist cloth and ensure no objects such as dirt, hair, sand are on the rubber seal ring. Do NOT use any oily solvent or chemicals for cleaning. 9. Rinse off the unit with tap water after use in salt water or swimming pool. 10. Power and/or charge the built-in rechargeable battery for portable use by connecting the USB cord to a computer USB connection or to an AC outlet using the AC-to-USB cord power adapter. 11.