User Manual

Power ON, Battery,
& LED Status Indicators
Once fully charged, press the Standby
Power Button on your Sol Jam.
You will see the green LED light & you
will hear an ascending bell tone.
IMPORTANT: Ensure the Main
Power Switch, located in the back
compartment under the cap, is set in
the Upper ON position. If the switch
is in the Lower OFF position, your
Sol Jam will not be able to turn on
using the Standby Button.
NOTE: The LED battery level
indicators are located on the top of
the unit. Each LED represents 20% of
a charge, with 5 full LEDs indicating a
full charge.
Audio playback time over Bluetooth
connection is approximately 12 hours
at 75% volume.
2
can be submerged in up to 3 feet of water for 30
minutes without any damage. However, the speaker
is not intended for constant underwater use.
Always make sure the cap(s) / covers(s) are clean,
free from sand or debris, and correctly fitted. The
speaker will only meet IP67 ratings if all rubber seals,
gasket(s), and cover(s) / cap(s) are in place. If you
notice a muffling of audio after submersion, gently
shake the unit to clear excess water. If your speaker
is exposed to salt water, clean it thoroughly after use
with fresh water.
The USB cables, power adapters, and unit with an
improperly fitted cap are NOT waterproof.
To prevent fire or shock, do NOT attempt to charge
this unit if it is wet or you suspect water has entered
the unit. In this situation, please return the unit to
Grace Digital for a free assessment. If we have found
that the unit has carried water, we will repair or
replace the unit free of charge.
SAFETY ADVISORY & WARNING:
Read and follow all instructions.
Use only as intended.
CAUTION: Do NOT open to repair. A qualified
technician must carry out repair work.
ATTENTION: Do NOT charge while the unit is wet.
Towel dry the unit AND make sure all
connections are dry BEFORE plugging
in the charging connector. Failure to do
so may result in electrical damage to
the unit and may void the warranty.