User Manual

FCC COMPLIANCE
STATEMENT & WARNING:
This device has been tested & found to comply with
the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful
interference in a residential installation. The device
generates, uses & can radiate radio frequency
energy & if not installed & used in accordance with
instructions may cause harmful interference to
radio communications. There is no guarantee that
interference will not occur in a particular installation.
If this device causes interference to radio or television
reception, try one of these measures: reorient or
relocate the receiving antenna, increase separation
between device & receiver, connect the device into
an outlet on a circuit different from that to which the
receiver is connected, consult a dealer or experienced
radio / TV technician for assistance. Changes or
modifications not expressly approved by the party
responsible for compliance could void the user’s
authority to operate the device and / or void the
manufacturer’s limited warranty.
PRODUCT USE AND PROTECTION:
Read and follow all instructions.
Use only as intended.
The ECOXGEAR Bluetooth speaker is intended to
be used indoors or outdoors and in land or water
environments. The speaker has been tested to IP67
waterproofing standards, which means the speaker
Bluetooth Pairing & Your Audio
Connecting With Bluetooth: Connect
To Your Smart Device & Play Audio
When your Sol Jam is turned on, the
blue LED light on the top panel will
flash rapidly indicating the unit is
ready to pair.
Turn on Bluetooth on your Bluetooth
device (Smart Device) and set the device
in pairing mode. Available Bluetooth
connections shall appear. Select the
ECOXGEAR speaker from the list of
discovered devices on your Bluetooth
device. Wait for a few seconds until the
connection is completed.
NOTE: Bluetooth connection feature
is found in the Settings section of
most mobile phones and other
Bluetooth enabled devices.
When the ECOXGEAR selection is
made and the Bluetooth connection
is completed, your Sol Jam will
announce: “Bluetooth connected”
3