Operation Manual

GRACE MX II Operating instructions
Page | 119
Using the assembly aid, lever the wheel rim over
the rim flange. Pump up the tube until the tyre
takes shape. Make sure it is positioned correctly
in the rim.
Pump up the tyre as per the manufacturer's
instructions and again check that the tyre is
positioned correctly in the rim.
Tighten the knurled nuts and screw the valve cap
onto the valve.
5.13. Assembly and disassembly of the pedals
Apply a thin layer of grease to the threads on the pedal axis and crank.
First of all, screw the pedal loose by hand. Make sure the parts are positioned at the correct
angle to each other and do not tilt.
The right pedal has a right-hand thread, the left pedal a left-hand thread to
the pedal axle for assembly onto the cranks. The right pedal is screwed in a
clockwise direction and the left pedal anti-clockwise.
Move the crank into a horizontal position so that
the pedal is facing the front wheel. Place the
open end spanner SW15 on the pedal axle and
hold the crank firmly on the opposite side.
Tighten the pedal with the torque according to
the data provided by the crank manufacturer.
Disassembly proceeds in the opposite direction to assembly.