Operation Manual

GRACE MX II Operating instructions
Page | 95
2.2. Removing the battery
Make sure the system has been switched off
before removing the battery. Turn the key in the
lock a quarter turn and at the same time, tilt the
battery to remove it out of the upper holder.
Next remove it from the lower holder.
In order to insert the battery, place it with its
contacts into the lower holder and tilt it into the
upper holder as far as it can go until the lock
audibly engages.
2.3. Important tips and advice about the battery
Only use original Bosch batteries which have been approved by the
manufacturer for the GRACE MX II. Using other batteries can lead to injuries
and the risk of fire.
If you want to stop using your GRACE MX II for a longer period of time (> 1
month), make sure that the battery is charged to approximately 60%, this is
equivalent to 3 – 4 LEDs on the display. Check the charge level after 6 months.
If only a single LED on the charge state indicator is still lit, recharge the battery
to around 60%.
The battery guarantees a minimum of 500 full charge cycles. You can extend
the life time of the battery by taking good care of it and by using it and storing
it at the right temperatures. We recommend operating temperatures
between +5 °C to +35 °C and an ambient temperature of +20 °C for storage.
Please follow the information in the original manual for the BOSCH Drive Unit
Performance | Intuvia | PowerPack 400 | Charger