Installation & Assembly

STEP 1: Unpack all the parts and classify them according

to the illustration shown at the side. Place the parts on a

scratch free surface.

STEP 2: lnstall the correct bulb (provided).

STEP 3: Install the glass shade to the body using the at

metal and hex nut.

STEP 4: Attach the xture and secure to the bottom frame

with ball nuts.

STEP 5: Make sure the power is turned off at the main

power cable where the xture is to be installed. Use the

wire nuts to connect the positive and neutral wires,

connect the ground wire to the junction box ground port.

STEP 6: Secure the xture to the post tter using

the screws.

Turn on the power at fuse or circuit box.

ASSEMBLY AND MOUNTING INSTRUCTIONS

CAUTION:

To reduce the risk of re, use the specied lamp wattage (or smaller) and bulb type identied on the product.

CLEANING INSTRUCTIONS:

Do not use polish or cleaners on your product. Just wipe clean with a soft cloth.

CAUTION – RISK OF FIRE

This product requires installation by a qualied electrician. Before installing be sure to read all instructions

and TURN THE POWER TO THE ELECTRICAL JUNCTION BOX OFF.

PLEASE READ THE ASSEMBLY INSTRUCTION SHEET CAREFULLY BEFORE PROCEEDING. Carefully unpack

and identify all parts prior to building the unit. Each part is identied on the drawing for reference.

DO NOT DISCARD THE ORIGINAL PACKAGING. If after careful inspection, you must return the item for any

reason. Please repack the unit using the original carton and inserts.

PAGE 1
ASSEMBLY AND MOUNTING INSTRUCTIONS PLEASE READ THE ASSEMBLY INSTRUCTION SHEET CAREFULLY BEFORE PROCEEDING. Carefully unpack and identify all parts prior to building the unit. Each part is identified on the drawing for reference. DO NOT DISCARD THE ORIGINAL PACKAGING. If after careful inspection, you must return the item for any reason. Please repack the unit using the original carton and inserts. STEP 1: Unpack all the parts and classify them according to the illustration shown at the side.
PAGE 2
ESPAÑOL: INSTRUCCIONES DE ENSAMBLAJE Y MONTAJE ANTES DE CONTINUAR, LEA DETENIDAMENTE LA HOJA DE INSTRUCCIONES DE ENSAMBLAJE. Desempaque con cuidado e identifique todas las piezas antes de armar la unidad. Cada pieza está identificada en el dibujo de referencia. NO DESECHE EL EMBALAJE ORIGINAL. Si después de una inspección exhaustiva tiene que devolver el artículo por algún motivo, vuelva a embalar la unidad con la caja original y los elementos internos de la caja.