Assembly And Installation Instructions

ASSEMBLY AND INSTALLATION
INSTRUCTIONS
Bulb Type B MAX 60W
(not included)
Fitter Screw (A)
Wire Nut (B)
Hardware Package (inculded):
Turn off the power at fuse or circuit
box.
Installation Steps
Handle
Roundhead
Screw
Flathead
Screw
Fixture body
Socket
Socket Tube
Cover Assembly
1. Unscrew the roundhead screws and
flathead screws to remove the handle from
the cover assembly and to remove the
cover assembly from the fixture body.
2. Place the socket tubes onto the sockets
to cover the sockets completly.
3. Install bulbs (not included). See relamping
label at socket area or packaging for
maximum allowed wattage.
4. Restore the handle and cover assembly
to the fixture body by the roundhead screws
and flathead screws.
5. Unscrew the fitter screws to remove the
fixture body away from the fitter.
6. Pull out the wires and grounding wire from the post.
Make wire connections using
the wire nuts:
---The black wire from the fixture to the black
wire from the post.
---The white wire from the fixture to the white wire
from the post.
---The grounding wire from the fixture to the
grounding wire from the post.
Carefully put the wires back into the post.
WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUIT
BREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE.
NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THESE INSTRUCTIONS.
Fitter Screw (A)
Grounding Wire
Wire Nut (B)
Post