Installation Instructions

1
Temporarily install the mounting plate to the junction box.
Mark the anchor hole locations on the mounting plate and remove the mounting plate.
Drill appropriate size holes at the marked locations and install the anchors.
Secure the mounting plate to the junction box.
Screw the anchor screws into the anchors.
Connect the fixture ground wire to a suitable ground in accordance to local electrical codes.
Connect the white fixture wire to the neutral power line wire with a wire nut.
Connect the black fixture wire to the hot power line wire with a wire nut.
Mount the fixture base onto the mounting plate and secure it with the set screw using an Allen wrench.
Screw the lamp into the socket. Refer to the label on the lamp socket for Max Wattage information.
1
2
3
4
5
CAUTION RISK OF FIRE-
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
1.0
W 1850B
1A
JUNCTION BOX
MOUNTING
PLATE
7
ALLEN WRENCH
8
SET SCREW
9
6
7
GP I :ENERAL RODUCT NFORMATION
This product is safety listed for damp locations.
Incandescent lamps may be dimmed with a standard incandescent dimmer.
LED LEDlamps may be dimmed with a dimmer. Consult lamp manufacturer for
additional information.
This instruction shows a typical installation.
LAMP
8
9
10
ANCHOR
ANCHOR
SCREW
4
4
3 5
Installation Instructions
These fixtures are intended to be installed utilizing NEC compliant junction
boxes.

Summary of content (3 pages)