Assembly Instructions

Carefully unpack all lamp parts from the carton.
1.Take the lamp carefully out of the Carton,and place it on a flat surface.
2.Be sure the power to the installation point is power off. This lamp must be installed on reinforced outlet box.
3.Fasten the Cross bar to the outlet box .Secure the Nipple onto the Canopy with Loop #1.
4.Secure Part A onto the Lamp Body by the Ball Finials on both sides.
5.Adjust chain length as needed. Thread Quick Link#1 into Loop #1 on the Canopy, then Quick Link #2
into Loop #2 on the top of Part A. Hand tighten until snug.
6.Pull the wire from the Canopy and then the center hole in the Cross Bar. The power supply wire consists of three wires,
one black wire, one white wire and one green ground wire.
7.Connect the wires as shown : A.Connect the House Gound Wire to the Fixture Ground Wire.
B.Connect the House White or Ribbed Wire to the Fixture Supply Wire (White or Ribbed Side).
C.Connect the House Black/Red Wire to the Fixture Supply Wire (Black or Smooth Side).
D.Wrap each connected wire with Wire Nut and carefully stuff all of the connected wires into the Outlet Box.
8.Put the Glass Shade onto the Shade Base separately with care.
9.Install correct bulbs to the socket referring to fixture markings and/or labels for maximum wattage. (Bulbs Included)
ASSEMBLY INSTRUCTIONS
Part A
Lamp Body