ASSEMBLY INSTRUCTION headboard • • CD 0 0 Connector Bed rail Footboard • @x2 Metal slat with plastic buckle Metal slat with a hole @Bx2 Silencing mat Middle bar • Side support leg ® �2 -------------....
Instruction Steps Attention: Do not tighten the screws until you have completed setup assembly. Step 1: Assemble the headboard((!)) and connector(@) together with screw(A) by hex wrench(G) as shown in picture below. Step 2: Attach the completed headboard((!)+@) to the bed rail @(part A and part B) with screws (C.D.F.I) as shown in picture below. Step 3: Attach the bed rail(@part A) and(@part B) to the side supporter(@) with screws(D.E.L) as shown in picture below.
Step 8: attach the middle metal slat(@)to the middle bar((J)) with Screw(B)and washer(I), please poke holes on the surface of the silencing mat before screw B go through the mat. Fix the middle slat (@) to the bed rail(@) with Screw(A). Step 8 Al Step 9: attach the plastic buckle to the metal slat, then pres x2Q Step 10: Lock all the bolts tightly and finish the assemble.