Owner Manual

Bulb Installation & Roof Assembly
a. For two screw and multiple screw assembly roofs, remove assembly
screws on roof and insert bulb(s). Reattach roof
(see figure 1 and 2).
b. For harp assembly roofs, unscrew top finial to remove font assembly
and roof from threaded nipple. Insert bulbs. Reattach roof, font
assembly and top finial (see figure 3).
c. For fixtures with a hinged door, lift latch
upwards to open door. Insert bulb(s) and relatch
the door (see figure 4).
d. For open bottom fixtures, insert bulb(s) through
bottom opening (see figure 5).
e. For screw on glass fixtures, unscrew glass
counter-clock wise, insert bulb(s) and screw
glass back on (see figure 6).
f. For front fitting screw glass fixtures carefully
loosening fitting screw, remove glass and
insert bulb. Reattach glass carefully by fitting
back of glass into shelf brackets, secure glass
with fitting screws. Note that the fitting screw
and the shelf bracket sit at different levels on
glass cove. (see figure 7).
f. To prevent water from entering the bullet
light fixture, do not position light beyond 65º
in any direction (see figure 8).
h. Turn on power.
Figure 2
Multiple Screw Assembly
Roof
Assembly
Screws
Font
Assembly
Figure 3
Harp Assembly
Threaded
Nipple
Roof
Top Finial
Font
Assembly
Figure 4
Hinged Door Assembly
Latch
Figure 5
Open Bottom Assembly
Figure 6
Screw on Glass Assembly
Figure 8
Directional Bullet Lights
Figure 1
Two Screw Assembly
Assembly
Screws
Roof
Figure 7
Front Fitting Screw
Fitting Screw
Shelf
Bracket
a. Empuje los cables nuevamente dentro de la caja eléctrica.
b. Coloque la tapa del tornillo para fijar la cúpula a la caja de
toma eléctrica, teniendo cuidado de no apretar demasiado.
c. Instale el vidrio antes de colocar las bombillas.
Monte de techo
Monte el Accesorio en el Cielo Raso
Si la lámpara no funciona:
1. Apague la lámpara y revise todas las conexiones de los cables.
2. Revise el fusible o el cortacircuitos y reemplácelo si es necesario.
3. Verifique que la bombilla está en buenas condiciones.
4. Verifique que el atenuador está “encendido”.
Localización de fallas
Utilice los tornillos de
ajuste para sujetar el
vidrio a la unidad,
teniendo cuidado de no
apretar demasiado ya
que el vidrio puede
romperse con la presión
excesiva. Coloque la(s)
bombilla(s).
Tornillos
de ajuste
Domo de cristal
Travesaño
Tornillo central
Casquete
Enrosque la tapa
Cables a tierra
Cables Blancos
Cables negros
E5S4