Parts
WARNING Before cleaning the gun nozzle or attempting to service the gun or other components, always turn off the high voltage first, then shut down paint pump and trigger gun to relieve fluid pressure. Be sure your installation complies with all applicable local codes. ALWAYS use the lowest pressure possible when flushing and use a grounded metal waste container. Grounding All components of the system, except the gun and paint hoses, must be electrically grounded.
NOTE: When increasing to a wide, flat pattern, increase supply of fluid to gun to maintain same coverage over larger area. Direction of changed by the desired TIGHT. DO spray pattern (horizontal or vertical) is loosening lock ring and turning air cap to position. TIGHTEN LOCK RING HAND NOT OVERTIGHTEN. Normal Spray Pattern .: >: Proper adjustment will grve a spray pattern shaped ## Iike this. $ $::i : . 0 Improper Spray Patterns Heavy on top or bottom, right or left.
should be taken when starting threads. Applied vide you with years of durability and efficiency These working parts require periodic replacement: 1. Air cap (7). 2. Fluid tip (6). 3. Needle, fluid (41). Removing Fluid Tip To remove fluid tip (6) for cleaning or replacement, remove the ring nut (8) and air cap (71, turn off the atomizing air, trigger the gun to release needle pressure on the tip. Remove the tip with a wrench. Replace with the needle triggered to the rear.
ELECTROSTATIC AUTOMATIC AIR SPRAY GUN Model 216-119 47 CHAMFERED END TOWARD NEEDLE Ref No. 39 Air Adjusting Screw Assy includes items / 26-26 and 36. HAND TIGHT (27-34 N-m) Torque to 15-19 ft-lb C20-25 N-m) I REF PART NO.
AIR CAP CONSUMPTION AND FLUID TIP FLOW RATE CHART 5 Approximate Pattern Length Air Cap 254 mm (10 in) Part Number from gun Air Consumption ma/min @ 2.06 bar (CFM e, 30 PSI) . / 177-666 177-d 177461 177463 Fluid Tip Part No 177532 355-710 591-1182 la351479 6-18 12-24 20-40 3550 1 mm 1.2 mm 1.5 mm 1.8 mm fO.040 in) (0.047 in) (0.060 in) (0.070 in) Description 177-033” 381-432 mm (15-17 in) 0.266 (9.5, Round end pattern, excellent atomization for automatic and hand gun high production.
ACETONE .05 MEG. 0.6 TEXTILC SPIRITS 1.06 BENZENE 1.2 TRICHLOAETHYLENE ETHYL ACETATE 0.46 MEG. I I METHVL 0. RES. MEK .05 MEG. ALCOHOL SC-1 soLvcSSodo TOLUOL 1.NITRO PROPANE .-_-. . -----..-- r METHYL AMYL ACETATE TURPENTINE NONE 1A 29’ 1.5 35 1.6 40’ 2.5 a 2.7 41 3.0 do 3.6 55 11.6 99 11.6 120 I1 3 110 14 AMYL ALCOHOL .06 MEG. SC.106 SOLVESSO.lW ETHYL CELLO. -- .oll _____^ SOLVt MLlJ. I I I DIACETONE .14 MEG. I DEPTINE MINERAL SPIRITS I I I BUTVL CELLOSOLVE 0.
DIMENSIONAL DRAWING , * ,. . . 0.5” (13 mm) DIA MOUNTING ROD HOLE MAX WIDTH 1.31” (33.