Texture Airless Spray Gun Parts List

30849110
Service
To reduce the risk of serious injury from fluid injec-
tion or splashing, always follow the Pressure
Relief Procedure on page 5 before servicing the
gun.
WARNING
Repair Notes
The needle and seat are available only as a kit which
includes items 2a to 2e.
The Standard Needle and Seat Kit, 237398, has the
number 090 stamped on the needle and seat.
A Non-diffused Needle and Seat Kit, 237260, has the
number 125 stamped on the needle and seat. It is rec-
ommended only for use with mastics, sealers and
other high viscosity materials which have fillers that
cannot pass through the standard seat’s diffuser .
Use high quality, general purpose grease where
grease is indicated.
Disassembly
NOTE: If replacing only the needle and seat, Step 4
and 5 are not required. However, removing them
allows you to clean the gun more thoroughly.
1. Relieve pressure.
Fig. 6
30
21
A
04731
2. Disconnect the fluid hose (A). Remove the tip
guard (30). Unscrew the spring screw (21) about
1/4 in. (7 mm) to release spring tension.
See Fig. 6.
Fig. 7
2a
2b
03969
3. Unscrew the valve seat (2a). Remove the gasket
(2b). See Fig. 7.
Fig. 8
29
28
27
18
25
0473
2
4. Remove one e-clip (27). Push out the pin (18).
Remove the screw (29), pivot pin (28), and trigger
(25). See Fig. 8.
Fig. 9
24
04733
5. Remove the screws (24). See Fig. 9.