Airless/Air-Assisted Sprayer Instruction Manual
Table Of Contents
- Warning
- Component Identification
- Component Identification
- Installation
- Pressure Relief Procedure
- General Repair Information
- Troubleshooting
- Displacement Pump Replacement
- Drive Housing Replacement
- Spin Test
- Fan Replacement
- Motor Brush Replacement
- Motor Brush Replacement
- Control Board Replacement
- On/Off Switch Replacement
- Fuse Replacement
- Removing and Installing Air Filter
- Compressor Replacement and Repair
- Pressure Control Replacement: FinishPro 390
- Drain Valve Replacement
- Drain Line Removal/Replacement
- Motor Replacement
- Motor Replacement
- Wiring Diagram
- Technical Data
- Warranty
Fuse Replacement
311911C 25
Fuse Replacement
FinishPro 390 only
Removal
1. Relieve pressure, page 7. Disconnect power cord
from outlet.
2. Remove two screws (30) and shroud (29) (see illus-
tration, page 16).
3. Remove fuse from control board.
4. Remove spare fuse from motor.
Installation
1. Replace fuse on control board with spare fuse.
2. Install shroud (29) and two screws (30) (see illustra-
tion, page 16).
Replaceable Fuse
ti6174b
ti9134b
Spare Fuse