Airless/Air-Assisted Sprayer Instruction Manual
Table Of Contents
- Warning
- Component Identification
- Component Identification
- Installation
- Pressure Relief Procedure
- General Repair Information
- Troubleshooting
- Displacement Pump Replacement
- Drive Housing Replacement
- Spin Test
- Fan Replacement
- Motor Brush Replacement
- Motor Brush Replacement
- Control Board Replacement
- On/Off Switch Replacement
- Fuse Replacement
- Removing and Installing Air Filter
- Compressor Replacement and Repair
- Pressure Control Replacement: FinishPro 390
- Drain Valve Replacement
- Drain Line Removal/Replacement
- Motor Replacement
- Motor Replacement
- Wiring Diagram
- Technical Data
- Warranty
Removing and Installing Air Filter
26 311911C
Removing and Installing Air Filter
Removal
1. Relieve pressure, page 7. Disconnect power cord
from outlet.
2. FinishPro 390: Unscrew filter (D) from back of
sprayer. Install new filter from Compressor Filter Kit
288724.
FinishPro 395:
a. Remove four screws (12) from back louvered
cover (64).
b. Unscrew filter (D) from back of sprayer. Install
new filter from Compressor Filter Kit 288724.
c. Install back cover (64) with four screws (12).
D
ti9266a
12
64
D
ti9261a