Airless/Air-Assisted Sprayer Instruction Manual
Table Of Contents
- Warning
- Component Identification
- Component Identification
- Installation
- Pressure Relief Procedure
- General Repair Information
- Troubleshooting
- Displacement Pump Replacement
- Drive Housing Replacement
- Spin Test
- Fan Replacement
- Motor Brush Replacement
- Motor Brush Replacement
- Control Board Replacement
- On/Off Switch Replacement
- Fuse Replacement
- Removing and Installing Air Filter
- Compressor Replacement and Repair
- Pressure Control Replacement: FinishPro 390
- Drain Valve Replacement
- Drain Line Removal/Replacement
- Motor Replacement
- Motor Replacement
- Wiring Diagram
- Technical Data
- Warranty
Compressor Replacement and Repair
311911C 27
Compressor Replacement and Repair
Removing Compressor from Sprayer
1. Relieve pressure, page 7. Disconnect power cord
from outlet.
2. Remove front and back louvers from sprayer.
3. Disconnect air fitting from compressor.
4. Disconnect electrical connection from solenoid
valve.
5. Remove compressor from sprayer. Follow instruc-
tions provided with your repair kit.
• To repair compressor, use Compressor Service
Kit 288723. Refer to Thomas Compressor
manual provided.
• Replace compressor piston assembly, use Kit
288723.
Front Louvers Back Louvers
ti9259a
ti9261a
ti9262a
ti9265a
ti9263a