Airless/Air-Assisted Sprayer Instruction Manual
Table Of Contents
- Warning
- Component Identification
- Component Identification
- Installation
- Pressure Relief Procedure
- General Repair Information
- Troubleshooting
- Displacement Pump Replacement
- Drive Housing Replacement
- Spin Test
- Fan Replacement
- Motor Brush Replacement
- Motor Brush Replacement
- Control Board Replacement
- On/Off Switch Replacement
- Fuse Replacement
- Removing and Installing Air Filter
- Compressor Replacement and Repair
- Pressure Control Replacement: FinishPro 390
- Drain Valve Replacement
- Drain Line Removal/Replacement
- Motor Replacement
- Motor Replacement
- Wiring Diagram
- Technical Data
- Warranty
Drain Line Removal/Replacement
311911C 33
Drain Line Removal/Replacement
FinishPro 390
Removal
To remove the drain line (40) from the manifold:
1. Cut drain line (40) from barbed fitting (20).
2. Unscrew barbed fitting (20) from manifold.
Installation
1. Screw barbed fitting (20) into manifold.
2. Push drain line (40) onto barbed fitting (20).
FinishPro 395
Removal:
Unscrew drain line (55) from filter manifold (15).
Installation:
Screw drain line (55) into filter manifold (15).
If you replace the manifold and reuse the existing
barbed fitting (20) and drain line (40), cut the
remaining drain line material off the end of the
barbed fitting (20) with a sharp knife.
To make the drain line more pliable and easier to
install on barbed fitting, heat drain line (40) end with
a hair dryer or place end in hot water a few seconds.
20
40
ti8333a
FinishPro 390 FinishPro 395
55 15
ti9603a