Installation Instructions
Start Up
8 333394P
Start Up
Starting a New Job
If you are using the sprayer for the very first
time, see Flushing a New Sprayer, page 22.
Strain the Paint
Previously opened paint may contain dried
paint or other debris. To avoid priming
problems and tip clogs it is advisable to strain
the paint before using. Two paint strainers
are included with the sprayer. Paint strainers
are available where paint is sold. Stretch a
paint strainer over a clean pail and pour the
paint through the strainer to capture any dried
paint and debris before spraying.
1. Install FlexLiner in the cup support.
2. Fill FlexLiner with material. Securely
tighten cup cover onto cup support.
Tighten so the arrow on the cup cover is
within range of the indicator on the cup
support.
Use only water-based or oil-based
(mineral spirit-type) materials with a
flash point greater than 100° F (38° C).
Do not use materials which state
“FLAMMABLE” on the packaging. For
more information about your material,
request SDS from distributor or retailer.
When spraying oil-based material, use
outdoors or in a well-ventilated indoor
area with a flow of fresh air.
Keep spray area well-ventilated. Keep
a good supply of fresh air moving through
the area.
NOTICE
Your sprayer is
NOT
compatible with harsh
cleaners such as chlorine bleach. Using
these cleaners will cause damage to the
sprayer.
ti26894a
ti23361a
ti24279a