Use and Care Manual

Setup
12 3A3208B
Setup
When unpacking sprayer for the first time or
after long term storage perform setup
procedure.
Assemble Your Sprayer
1. Connect Graco airless hose to fluid
outlet. Use wrench to tighten securely.
2. Connect other end of hose to gun.
3. Use two wrenches to tighten securely. If
hose is already connected, make sure
connections are tight.
4. Engage trigger lock.
5. Remove tip guard. Be careful tip seal
may fall out when tip guard is removed.
6. Turn pressure control knob all the way
left (counter-clockwise) to lowest set-
ting.
7. After long term storage check inlet
strainer for clogs and debris.
Strain the Paint
Previously opened paint may contain dried
paint or other debris. To avoid priming prob-
lems and spray tip clogs it is recommended
to strain the paint before using. Paint strain-
ers are available where paint is sold. Stretch
a paint strainer over a clean pail and pour
the paint through the strainer to capture any
dried paint and debris before spraying.
ti27122a
ti25199a
ti25196b
ti25197a
ti27493a
ti26894a