Full Product Manual

Common Procedures
3A4433B 23
Common Procedures
Spray Tip Installation
To prevent spray tip leaks make certain spray
tip and tip guard are installed properly.
1. Perform Pressure Relief Procedure,
page 10.
2.
Use spray tip (A) to insert seal (B)
into tip guard (C).
3. Insert Spray Tip. Spray tip must be
pushed all the way into the tip guard.
4. Screw spray tip and tip guard assembly
onto the gun and hand tighten.
• Spray tips wear with use and abrasive
paint and need periodic replacement.
• If the spray pattern is poor, you may have
a worn spray tip. Replace spray tip. See
Spray Pattern Diagnostics, page 35.
Flush a New Sprayer
This sprayer arrives from the factory with a
small amount of test material in the system.
It
is important that you flush this material
from the sprayer before using it for the first
time.
See Cleaning Fluid Compatibility ,
page 27 and
Static Grounding Instructions
(Oil-Based materials)
, page 27 for additional
information when using oil-based materials.
1. Remove cup assembly from the sprayer
by turning and pulling down.
To avoid serious injury from skin injection
do not put your hand in front of the spray tip
when installing or removing the spray tip
and tip guard.
ti24653a
C
B
A
ti24664a
NOTICE
Spray tips must be cleaned or stored in
appropriate cleaning fluid (water or mineral
spirits) immediately after use to ensure
material is not allowed to dry in spray tip.
Failure to do so will result in damage to the
spray tip. See Cleanup, page 18.
ti29775a