Full Product Manual
Start Up
14 3A4803B
If sprayer does not spray, try one of
the steps below:
•
Make certain there is only one FlexLiner
in cup support. It is possible for two liners
to nest tightly together and appear as
only one.
• Make certain the cup cover is properly
threaded to the cup support. If threads
are visible below the cup cover when
tight, then the cover is cross-threaded.
Fully remove the cup cover and reinstall
to the cup support so no threads are
visible when tight.
•
Repeat steps 2 – 6 on page 12 to ensure
all the air is evacuated from the FlexLiner.
• Make certain the Prime Pump/Spray
knob is in the Spray position.
• If sprayer still does not spray, see
Sprayer Diagnostics, page 35. If
material sprays while upside down there
is air in the cup. Repeat steps above.
•
Replace VacuValve cap. Two new
VacuValve caps came with your sprayer.
Refilling FlexLiner
If sprayer runs out of paint simply separate
the cup support from the cup cover/sprayer
and refill the FlexLiner.
1. Remove battery from the sprayer and
open the vacuvalve to allow air into the
FlexLiner.
2. Separate the cup support from the
cup
cover/sprayer.
Set the sprayer upside
down on a flat surface. This will keep the
wet paint in the cup cover.
3. Follow steps 2 – 12 in Starting a New
Job, page 12.
ti29741a
ti29739a
When spraying flammable or combustible
materials:
• Move entire sprayer to a well-ventilated
area and away from flammable or
combustible materials, including paints
and solvents when refilling.
• Keep material containers covered
between cup refills.
ti29742a