Full Product Manual

How to Spray
3A4803B 15
How to Spray
Take a few moments prior to spraying and
review these simple tips to ensure your
spraying project is a success.
NOTE: For proper sprayer operation use only
a tip from the same tip family that came with
your sprayer.
Speed Control
The speed control allows for infinite pressure
adjustment. To reduce overspray, always
start at lowest speed setting and increase
speed to the minimum setting that results in
an acceptable spray pattern.
Tip and Pressure Selection
See table for recommended spray pressure for your material. Refer to paint (material) can for
manufacturer’s recommendations.
Spray Techniques
Use a piece of scrap cardboard to practice
these basic spraying techniques before you
begin spraying the surface.
• Hold sprayer 12 in. (30 cm) from surface
and aim straight at surface. Tilting the
sprayer to direct the spray angle causes
an uneven finish.
• Flex wrist to keep sprayer pointed
straight. Fanning sprayer to direct spray
at angle causes uneven finish.
NOTE: How fast you move the sprayer will
affect spray application. If material is uneven,
you are moving too fast. If material drips, you
are moving too slow. See Troubleshooting,
page 35.
Sprayer Name Tip Family Tip Part No.
Ultra FFLP FFLPxxx
Ultimate FFLP FFLPxxx
TC Pro TCP TCPxxx
ti29773a
Coatings
Interior
Stains/
Interior &
Exterior
Clears
Exterior
Solid Stains Enamels Primers
Interior
Latex
Paints
Exterior
Latex
Paints
Speed Control 1 – 5 6 – 10 6 – 10 6 – 10 6 – 10 6 – 10
Tip hole Size
0.008 in. (0.20 mm)

0.010 in. (0.25 mm)

0.012 in. (0.30 mm)

0.014 in. (0.36 mm)

0.016 in. (0.41 mm)
