Full Product Manual

Common Procedures
22 3A4476D
Common Procedures
Spray Tip Installation
To prevent spray tip leaks make certain spray
tip and tip guard are installed properly.
1. Perform Pressure Relief Procedure,
page 9.
2.
Use spray tip (A) to insert seal (B)
into tip guard (C).
3. Insert Spray Tip. Spray tip must be
pushed all the way into the tip guard.
4. Screw spray tip and tip guard assembly
onto the gun and hand tighten.
• Spray tips wear with use and abrasive
paint and need periodic replacement.
• If the spray pattern is poor, you may have
a worn spray tip. Replace spray tip. See
Spray Pattern Diagnostics, page 33.
To avoid serious injury from skin injection do not
put your hand in front of the spray tip when
installing or removing the spray tip and tip guard.
ti24653a
C
B
A
NOTICE
Spray tips must be cleaned or stored in
appropriate cleaning fluid (water or mineral
spirits) immediately after use to ensure
material is not allowed to dry in spray tip.
Failure to do so will result in damage to the
spray tip. See Cleanup, page 17.
ti24664a