Full Product Manual

Setup
12 3A5725C
Setup
When unpacking spray system for the first
time or after storage, perform setup
procedure.
1. Check material nozzle before spraying
to ensure there is not an air blockage.
Clean before using.
2. Make sure hopper air passageway and
air supply tube are free of debris. Clean
before using.
3. Connect one end of air hose to the
compressor air outlet fitting and the other
end to the gun air inlet fitting.
4. Test gun trigger. Lubricate needle seals
if necessary.
5. Install material nozzle on front of gun and
secure using retaining ring. Pulling the
trigger when installing nozzle makes
assembly easier.
NOTICE
•
Do not store spray system under
pressure. This may cause damage to
the spray system.
• Do not allow material to dry inside
hopper, hoses, gun nozzles or spray
system. This may cause system to fail.