Full Product Manual

Start Up
16 3A6430C EN
Strain the Paint
Disposable paint strainer bags are used to
remove coarse particles and debris from
new or previously opened paint or stain, and
are available where paint is sold. To avoid
priming problems and Spray Tip clogs it is
recommended to strain all paints and stains
before spraying. Stretch a disposable paint
strainer bag over a clean pail and pour the
paint through the strainer.
Fill Pump (Prime Pump)
The Prime/Spray Valve directs the fluid to
either the Drain Tube or the hose and gun. It
is used to prime the sprayer, which means to
evacuate the air out of the pump, hose, and
gun.
Your gun will not spray if there is air in the
system. It is necessary to prime the pump,
hose, and gun any time air enters the suction
tube.
1. Move Suction Tube to paint pail and
submerge Suction Tube in paint.
2. Turn ON/OFF switch to ON position.
3. Wait to see paint coming out of Drain
Tube.
4. Turn ON/OFF switch to OFF position.
NOTE: If paint does NOT flow up the Suction
Tube and out the Drain Tube, see Flush
Storage Fluid, page 15.
Fill Gun and Hose
1. Rotate Spray Tip to UNCLOG position
and ensure the Spray Tip Guard is tight.
2. Hold gun against waste pail. Point gun
into waste pail.
a. Disengage trigger lock (A).
b. Pull and hold gun trigger (B).
c. Lower Prime/Spray Valve to
SPRAY position (C).
d. Turn ON/OFF switch to ON position
(D).
3. Trigger gun into waste pail until only
paint comes out of the gun.
High-pressure spray is able to inject toxins
into the body and cause serious bodily
injury. Do not stop leaks with hand or rag.
ti26894a