Use and Care Manual

3A5280B
EN, ES
Storage/Priming Tool for
Magnum Airless Sprayers
PRIME: Perform the steps below if you are experiencing
difficulty priming your sprayer.
1. Turn or lift Prime/Spray valve
to the PRIME position to
relieve pressure.
2. Remove Pump Armor bottle
cap. Insert small fluid tube
into bottom of Storage/Prime
Tool, and thread tool onto the
bottle. NOTE: For best
results, make sure the bottle
is full of Pump Armor.
3. Remove sprayer suction tube.
Insert tool into the inlet and
push up firmly until it stops.
4. Squeeze Pump Armor bottle
until Pump Armor flows into
the drain tube.
5. Remove tool. Replace and
tighten child-proof cap for
storage.
6. Reinstall the sprayer suction
tube. Ensure that the tube is
snug on the inlet and the
clamp is engaged.
STORE: After cleaning your sprayer, perform the steps below when storing.
1. Perform cleaning procedures
found in your Owner’s Manual.
1. Remove Pump Armor bottle
cap. Unscrew Inlet Strainer
from suction tube.
2. Turn or lift Prime/Spray Valve
to relieve pressure and place
drain tube in a waste pail.
3. While holding the suction tube
above the sprayer, pour a
small amount of Pump Armor
into the Suction Tube. Turn
Power Switch ON.
4. When Pump Armor is flushed
through the sprayer, turn
Power Switch OFF. Replace
and tighten child proof cap for
storage.
5. Screw Inlet Strainer back to
suction tube. Ensure that
spray gun and hose stay
attached to sprayer.
6. Turn or lower Prime/Spray
valve to SPRAY position for
storage.
PRO
All Other Models
Important Safety Instructions
Read all warnings and instructions in the sprayer
manual and on the unit, including the power cord.
Be familiar with the controls and the proper usage
of the equipment.
Magnum Storage Tool
http://magnum.graco.com/storagetool