User's Manual

3307252
Installation
To clean or service the filter without shutting down the system,
install a dual filter or a filter bypass system as explained below.
The numbers and letters in parentheses refer to Figs. 1, 2, and
3 and the Parts Drawing. Accessories and Technical Data are
on the page 5.
NOTE: Allow 3 in. (76 mm) minimum clearance below the filter
for easy removal of the bowl (10).
Fluid Drain Valve (required in all systems)
W
A
R
N
I
N
G
A fluid drain valve is required in the base of each fluid filter.
Use this drain valve to relieve fluid pressure in the filter, to
reduce the risk of serious injury, including fluid injection and
splashing in the eyes or on the skin.
Remove the 3/4 unf plug (12) from the bottom of the filter and
install a high pressure adapter and drain valve (A,B). See Fig.
2.
Dual Filter System
This setup enables you to redirect the fluid to another filter while
one filter is cleaned or serviced.
Install two filters as shown in Fig. 2. Install four suitable shutoff
valves (D), one at each filter and outlet, to redirect the fluid and
isolate the filter not in use.
Filter Bypass System
This setup enables you to redirect the fluid through pipes which
bypass the filter while cleaning or servicing the filter.
Install the filter and bypass pipes as shown in Fig. 1. Install four
suitable shutoff valves (D), one each at the filter inlet, the filter
outlet, the bypass pipe inlet, and the bypass pipe outlet. These
valves redirect the fluid and isolate the filter while cleaning and
servicing.
Fig. 1
03710
D D10
A,B
IN OUT
Filter Bypass System
Fig. 2
03709
A,B
D
10
D
D
D
A,B
10
IN OUT
Dual Filter System
Dimensions
M
o
u
n
t
i
n
g
D
i
m
e
n
s
i
o
n
s
2X 3.0 in.
(7.62 cm)
2X 1.5 in.
(3.81 cm)
2X 2.5 in.
(6.35 cm)
2X .39 in
(.99 cm)
3/8--16 UNC
TI15744a
B
a
s
i
c
O
v
e
r
a
l
l
D
i
m
e
n
s
i
o
n
s
8.16 in.
(20.73 cm)
11.3 in.
(28.7 cm)
4.5 in.
(11.43 cm)
TI15743a