User's Manual

ManualsBrandsGraco ManualsFiltersGraco 307283D Red Alert Filters Low Pressure High Volume

307–283

Rev. D

Supersedes Rev. C

First

choice when

quality counts.



03708

INSTRUCTIONS-PARTS

LIST

INSTRUCTIONS

This

manual contains important

warnings and information.

READ AND KEEP FOR REFERENCE.

Low Pressure, High Volume

“Red

Alert” Filters

300 psi (2.1 MPa, 21 bar) Maximum Working Pressure

gpm (76 liter/min) Flow Capacity

225 in.

(1450 cm

) Filtering Area

Model 213–062

With

30 mesh (590 micron) element

Model 213–063

With

60 mesh (250 micron) element

Model 213–064

With

100 mesh (149 micron) element

Model 213–065

With

150 mesh (95 micron) element

Model 213–066

With

200 mesh (74 micron) element

Model 214–002

Less

element – See

Parts

on page 6 for element

numbers.

GRACO INC. P.O. BOX 1441

MINNEAPOLIS, MN

55440–1441

COPYRIGHT

1977, GRACO INC.

Graco

Inc. is registered to I.S. EN ISO 9001

Summary of content (8 pages)

PAGE 1
INSTRUCTIONS-PARTS LIST This manual contains important warnings and information. READ AND KEEP FOR REFERENCE. 307–283 Rev. D Supersedes Rev. C First choice when quality counts. INSTRUCTIONS Low Pressure, High Volume “Red Alert” Filters 300 psi (2.1 MPa, 21 bar) Maximum Working Pressure 20 gpm (76 liter/min) Flow Capacity 225 in.
PAGE 2
Table of Contents Warnings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Service . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Parts . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Technical Data . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Graco Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . .
PAGE 3
Notes 307–283 3
PAGE 4
Installation Notes: Filter Bypass System To clean or service the filter without shutting down the system, install a dual filter or a filter bypass as explained below. This setup enables you to redirect fluid through pipes which bypass the filter, while cleaning or servicing the filter. The numbers and letters in parenthesis refer to the Figures and the Parts Drawing. Be sure to allow 4 in. (102 mm) minimum clearance below the filter for easier removal of the bowl (9).
PAGE 5
Service WARNING PRESSURIZED EQUIPMENT HAZARD Before removing, cleaning, or servicing the filter, close the inlet and outlet ball valves (D, Fig. 1) and open the fluid drain valve (B) to relieve pressure. CAUTION If the filter will not be used for awhile, thoroughly clean all the parts in solvent and blow them dry before the paint dries and clogs the filter. To help prevent damaging the parts, do not clean them with a wire brush or sharp object.
PAGE 6
Parts Note: Model 214–002 includes items 1–6 and 8–10, but does not include a filter element as standard. Select the desired filter element from those listed under Ref. No. 7 Model 213–062 to 213–066 Include Items 1–10 Note: All other models are the same as 214–002, but do include a filter element as standard, as listed under Ref. No. 7. Model 214–002 Include Items 1–6, 8–10 1 2 3 Ref. No. Part No.
PAGE 7
Technical Data Category Data Dimensions 6.06” (154 mm) Wide; 5.5” (140 mm) Deep; 11” (280 mm) High Weight 7 lb (3.2 kg) Maximum Working Pressure 300 psi (2.1 MPa, 21 bar) Flow Capacity 20 gpm (76 liters/min) Filter Area 225 in.2 (1450 mm2) Wetted Parts Anodized Aluminum, Viton ; 300 Series Stainless Steel, PTFE, Plated Steel Viton is a registered trademark of the Du Pont Corporation.
PAGE 8
The Graco Warranty and Disclaimers Graco warrants all equipment listed in this manual which is manufactured by Graco and bearing its name to be free from defects in material and workmanship on the date of sale by an authorized Graco distributor to the original purchaser for use. With the exception of any special extended or limited warranty published by Graco, Graco will, for a period of twelve months from the date of sale, repair or replace any part of the equipment determined by Graco to be defective.