User's Manual

5307517
WARNING
INSTRUCTIONS
EQUIPMENT MISUSE HAZARD
Equipment misuse can cause the equipment to rupture, malfunction, or start unexpectedly and result
in a serious injury.
D This equipment is for professional use only.
D Read all the instruction manuals, tags, and labels before operating the equipment.
D Use the equipment only for its intended purpose. If you are uncertain about usage, call your Graco
distributor.
D Do not alter or modify this equipment. Use only genuine Graco parts and accessories.
D Check the equipment daily. Repair or replace worn or damaged parts immediately.
D Do not exceed the maximum working pressure of the lowest rated system component. This equip-
ment has a 5000 psi (34.4 MPa, 344 bar) maximum inbound fluid pressure.
D Use fluids that are compatible with the equipment wetted parts. See the Technical Data section of
all the equipment manuals. Read the fluid manufacturer’s warnings.
D Route the hoses away from traffic areas, sharp edges, moving parts, and hot surfaces. Do not
expose Graco hoses to temperatures above 180_F (82_C) or below –40_F (–40_C).
D Do not kink or over bend the hoses or use the hoses to pull equipment.
D Wear hearing protection when operating this equipment.
D Comply with all applicable local, state, and national fire, electrical, and other safety regulations.
D If your spray or extruder gun has a lower pressure rating than the pump, be sure you adjust its fluid
regulator low enough to avoid exceeding the gun’s maximum working pressure.
MOVING PARTS HAZARD
Moving parts, such as the air motor piston, can pinch or amputate fingers.
D Do not operate the equipment with the air motor plates removed.
D Keep clear of any moving parts when starting or operating the equipment.
HOT SURFACE AND FLUID HAZARD
Heated fluid can cause severe burns and can cause equipment surfaces to become very hot.
D Wear protective gloves and clothing when operating this equipment in a heated system.
D Do not touch the metal heat sink when the surface is hot.
D Allow the equipment to cool thoroughly before servicing.
Some heated systems are designed to dispense Polyurethane (PUR) heated materials. PUR systems
are supplied with ventilation hoods, and require proper ventilation and specially designed system
components.