User's Manual

16 308357
Service
Reassembly
1. If it was necessary to remove the piston ball
housing (12) from the displacement rod (1), clean
the threads of the rod and the ball housing, and
apply thread sealant. Screw the ball housing onto
the rod, hand tight. Place the flats of the piston ball
housing in a vise and torque the rod to 386–407
N.m (285–300 ft–lb). See Fig. 8.
2. Place the piston packings on the piston seat
housing (14) in the following order, with the lips
of the v-packings facing up: the female gland
(4*), one PTFE v-packing (3*), four leather
v-packings (5*), and the male gland (6*). See the
Piston Packing Stack Detail in Fig. 8.
NOTE: To convert the pump to a different packing
material, see page 20.
3. Place the flats of the piston seat housing (14) in a
vise. Place the ball (13*) on the piston seat (E).
Screw the piston ball housing (12) onto the piston
seat housing hand tight, then torque to 386–407
N.m (285–300 ft–lb). See Fig. 7.
4. Lubricate the throat packings and place them in
the outlet housing (9) in the following order, with
the lips of the v-packings facing down: the
male gland (6*), four leather v-packings (5*), one
PTFE v-packing (3*), and the female gland (4*).
See the Throat Packing Stack Detail in Fig. 8.
NOTE: To convert the pump to a different packing
material, see page 20.
5. Lubricate the threads of the packing nut (2), and
loosely install it in the outlet housing (9).
6. Lubricate the piston packings. Slide the displace-
ment rod (1) and piston assembly down into the
cylinder (11). The cylinder is symmetrical, so either
end may face up. Use a rubber mallet to drive the
rod into the cylinder, until the piston seat housing
(14) is near the bottom of the cylinder.
7. Place the intake ball guide (27) in the intake hous-
ing (16). Set the intake housing in the vise, facing
upright. See Fig. 6.
8. Install the o-ring (10*) on the bottom of the cylinder
(11). Lubricate the o-ring. Place the cylinder on the
intake housing (16). Tap the top of the displace-
ment rod (1) with a rubber mallet, to seat the
cylinder.
9. Install the o-ring (10*) on the top of the cylinder
(11). Lubricate the o-ring. Set the outlet housing
(9) on the cylinder.
10. Apply thread lubricant to the six long cap screws
(29). Install them through the outlet housing (9)
and thread them loosely into the intake housing
(16). Tighten the screws oppositely and evenly
with a socket wrench, then torque to 244–264 N.m
(180–195 ft-lb). See Fig. 8.
11. Place the pump lengthwise in the vise, with the
jaws on the outlet housing (9) as shown in Fig. 5.
12. Install the o-ring (28*) on the intake valve (17).
Lubricate the o-ring and the threads of the intake
valve. Place the intake ball (15*) in the intake
housing (16), then screw the intake valve into the
intake housing handtight.
13. Using a pipe wrench, torque the intake valve (17)
to 522–542 N.m (385–400 ft–lb). See Fig. 5.
14. Torque the packing nut (2) to 129–142 N.m
(95–105 ft–lb).
15. Reconnect the displacement pump to the air motor
as explained on page 12.