User's Manual

ManualsBrandsGraco ManualsLubrication Dispense MetersGraco 308687H - IM5 Inline Electronic Meter

10 308687

Troubleshooting

PRESSURIZED EQUIPMENT HAZARD

The equipment stays pressurized until pressure is

manually relieved. To reduce the risk of serious

injury from pressurized fluid, accidental spray from

the dispenser, or splashing fluid, follow the Pres-

sure Relief Procedure whenever you

D Are instructed to relieve pressure

D Stop dispensing

D Check, clean, or service any system equipment

D Install or clean fluid nozzles

WARNING

Pressure Relief Procedure

1. Turn off the power supply to the pump.

2. Trigger the valve into a waste container to relieve

pressure.

3. Open any bleed-type master air valves and fluid

drain valves in the system.

4. Leave the drain valve open until you have com-

pleted repairs and are ready to pressurize the

system.

NOTE: Before you check or repair the meter, be sure

all other valves, controls, and the pump are operating

properly.

Problem Cause Solution

Battery icon is

shown on the

display.

Battery is low. Replace the battery. See Replacing the Battery on

page 8. See Technical Data on page 11 for the

recommended battery.

Digital display

does not activate.

Battery is low.

Electronic control is malfunctioning.

Replace battery. See Replacing the Battery on page

8. See Technical Data on page 11 for the

recommended battery.

Replace electronic control.

There is no fluid

flow.

Metering unit is malfunctioning. Replace the meter.

Strainer, if used, is clogged. Remove and clean strainer.

Pump is not turned on. Turn on the pump.

Parts

Model 239824 (Includes replaceable items 1–3)

Ref.

No. Part No. Description Qty.

1 245598* CONTROL, electronic 1

2 113930 GASKET 1

3 113941 SCREW 4

4 UNIT, Metering (cannot be sold

separately) 1

* Replacement screws and gasket are

included with item 1.

TI1706A