User's Manual

4 309962
WARNING
FIRE AND EXPLOSION HAZARD
Improper grounding, poor air ventilation, open flames, or sparks can cause a hazardous condition and
result in a fire or explosion and serious injury.
D Do not use this equipment in a hazardous area, as defined in Article 500 of the National Electrical
Code (USA).
D Ground the equipment and the object. See Ground the System on page 6.
D Provide fresh air ventilation to avoid the buildup of flammable fumes from solvent or the fluid being
dispensed.
D Extinguish all the open flames or pilot lights in the dispense area.
D Keep the dispense area free of debris, including solvent, rags, and gasoline.
D Do not turn on or off any light switch in the dispense area while operating or if fumes are present.
D Do not smoke in the dispense area.
D Do not operate a gasoline engine in the dispense area.
D If there is any static sparking while using the equipment, stop dispensing immediately. Identify
and correct the problem.
D Keep a fire extinguisher in the work area.
INSTRUCTIONS
EQUIPMENT MISUSE HAZARD
Equipment misuse can cause the equipment to rupture, malfunction, or start unexpectedly and result
in a serious injury.
D This equipment is for professional use only.
D Read all the instruction manuals, tags, and labels before operating the equipment.
D Use the equipment only for its intended purpose. If you are uncertain about usage, call your Graco
distributor.
D Do not alter or modify this equipment. Use only genuine Graco parts and accessories.
D Check the equipment daily. Repair or replace worn or damaged parts immediately.
D Do not exceed the maximum working pressure of the lowest rated system component. See the
front cover or the Technical Data for the maximum working pressure of your gun model.
D Route the hoses away from the traffic areas, sharp edges, moving parts, and hot surfaces.
D Do not kink or overbend hoses or use the hoses to pull the equipment.
D Use only Graco approved hoses. Do not remove hose spring guards, which help protect the hose
from rupture caused by kinks or bends near the couplings.
D Use fluids or solvents that are compatible with the equipment wetted parts. See the Technical
Data section of all the equipment manuals. Read the fluid and solvent manufacturer’s warnings.
D Do not use 1,1, 1-trichloroethane, methylene chloride, other halogenated hydrocarbon solvents or
fluids containing such solvents with guns. Such use could result in a serious chemical reaction with
the gun’s aluminum parts, with the possibility of an explosion.
D Comply with all applicable local, state and national fire, electrical and other safety regulations.