User's Manual

Installation
14 313869K
Mount Gun
Reciprocating Arm Rod Mount
To mount the gun on a reciprocating arm rod
[0.75 in. (19 mm) diameter maximum], insert
the bar (A) through the hole in the manifold as
shown in F IG . 3.
NOTE: Use the 1/8 in. alignment slot (P) to
assist in orienting the gun.
Secure the gun to the bar by tightening the
mounting screw (B).
Stationary Support
To mount the gun on a stationary support,
refer to F IG . 4 and to the correct mounting hole
layout for your gun, page 34 - 35.
1. Align the gun or manifold with the align-
ment pins. Locate alignment slot and holes
per the mounting hole layout.
2. Secure the gun to the support with two M8
x 1.25 capscrews (C). The screws must be
long enough to engage the threaded holes
to a depth of 1/4 in. (6 mm).
F IG . 3: Reciprocating Arm Mount
B
P
A
TI14433A
F IG . 4: Stationary Support Mount
C
TI14434A
TI14435A
Guns without manifold
Guns with manifold
C