User's Manual

Overview
10 332144C
Overview
The Reactor E-10hp is a portable, electric-powered, 1:1
mix ratio proportioner for use with:
•Polyurea
• Polyurea hybrid coatings
• Polyurethane foam
Material may be applied with impingement mix spray
guns.
The Reactor E-10hp is gravity-fed from 6 gal. (22.7 liter)
supply tanks mounted on the unit.
Severe duty, positive displacement reciprocating piston
pumps meter fluid flow to the gun for mixing and apply-
ing. When set to recirculation mode, Reactor E-10hp will
circulate fluids back to the supply tanks.
The Reactor E-10hp uses primary heating rods and
boost heating rods, for each fluid, and an insulated hose
bundle with circulation return hoses. This allows the
hoses and gun to be preheated to the desired tempera-
ture before spraying. The boost heating rods are used
during circulation mode to reduce heatup time. Digital
displays show the temperatures of the two fluids.
Electronic controls monitor fluid pressures, drive the
motor, and alerts the operator if errors occur. See
Motor/Pump Status Codes, page 14, for further infor-
mation.
The Reactor E-10hp has two recirculation speeds, slow
and fast, and an adjustable pressure output.
Slow Recirculation
• Slow circulation results in a higher temperature
transfer in the heater, so hoses and gun heat up
quicker.
• Good for touchup or low flow spraying, up to moder-
ate temperature.
• Not used to circulate full tanks up to temperature.
• Use with 245 fa blowing agent foams, to minimize
heat returned to tank and reduce frothing.
Fast Recirculation
• Use to support higher flow rates or higher tempera-
tures by preheating the tanks.
• Agitates fluid within tanks, to avoid heating only the
fluid at the top of the tank.
• Use for flushing.
Pressure Adjust
Automatically maintains selected pressure output for
dispensing or spraying.