User's Manual

Flushing

26 332144C

9. Set function knob to Fast Recirc . Pump solvent

through system to waste containers.

10. When nearly clear solvent comes from recirculation

tubes, set function knob to Stop/Park . Return

recirculation tubes to supply tanks.

11. Set function knob to Fast Recirc . Circulate sol-

vent through system for 10-20 minutes to ensure

thorough cleaning.

NOTE: To flush gun, refer to gun instruction manual.

Purge Hoses

Disconnect hoses from gun and secure back into the

tanks for thorough cleaning with solvent.

• Turn Recirc/Spray valve ISO to Spray.

• Open gun into waste ISO container.

• Set function knob to Slow Recirc until hose is

flushed.

• Set function knob to Stop/Park .

• Repeat for RES side.

12. Set function knob to Stop/Park .

13. Solvent flushing is a two step process. Go back to

step 4, drain solvent, and flush again with fresh sol-

vent.

14. Leave unit filled with solvent, plasticizer, clean

motor oil, or refill supply tanks with new material and

reprime.

NOTE: Never leave the unit dry unless it has been dis-

assembled and cleaned. If fluid residue dries in the

pumps, the ball checks may stick the next time you use

the unit.

ti31496a

STATUS

ti21490a

ti31496a