User's Manual

ManualsBrandsGraco ManualsSprayersGraco 332144C - Reactor E-10hp

Repair

332144C 53

Electric Motor

Test Motor

If motor is not locked up by pumps, it can be tested

using a 9 V battery.

1. Open recirculating valves.

2. Disconnect motor connections from control board,

see F

. 12, page 45. Touch jumpers from battery to

motor connections. Motor should turn slowly and

smoothly.

Removal

NOTE: See wiring schematic, page 45.

1. See Before Beginning Repair, page 39.

2. Relieve pressure, page 23.

3. Remove four screws (91), shroud (89), and mount-

ing brackets (233). See F

. 18.

4. Remove fans (16) and disconnect cable (80). See

. 20.

5. Remove drive housing/pump assemblies, page 51.

6. Remove display control cover (26). Disconnect

motor cables as follows:

a. Unplug motor power connector before ferrite

(88).

b. Unplug motor temp switch harness from con-

nector J9 and remove grounding cable from

grounding screw.

7. Remove RES supply tank. See Remove Supply

Tank, page 39.

8. Cut zip ties.

9. Thread motor power switch harness and over temp

switch out bottom of control module and cable chan-

nel, to free motor.

10. Remove screws (15) holding motor (201) to bracket.

Lift motor off unit.

11. If replacing motor, remove shroud mounting bolts

(207) and brackets (233) and set aside.

Installation

1. If replacing motor, install fan assemblies (16) and

shroud mounting brackets (233) on new motor

(201).

2. Place motor (201) and fans (16) on unit. Thread

motor switch harness through grommets in cart and

into the back of the display. See F

. 24 on page 73.

3. Fasten motor (201) with screws (15) underneath.

Do not tighten yet.

4. Plug motor temp switch harness to connector J9

and grounding cable from grounding screw.

5. Plug in motor power connector.

6. Secure all cables to cart frame with zip ties.

7. Install display control cover (26).

8. Install supply tank.

9. Install drive housing/pump assemblies, page 51.

Reconnect inlet assemblies to pumps.

10. Torque screws (15) to 150 in.-lbs (17 N•m).

11. Return to service.

NOTICE

To prevent dropping the motor, two people may be

required to lift.