Kit Instructions Bead Gun Kit for LL250SPS and LL200HS Pressurized Bead System For professional use only. Model 16R963 psi (MPa, bar) Maximum Working Pressure Important Safety Instructions Read all warnings and instructions in the bead system and striper manual. Be familiar with the controls and the proper usage of the equipment. Save these instructions.
Tools Needed: Tools Needed: • Wrench • Adjustable Wrench • Phillips Screwdriver • Cutting Blade 4. Slide bead gun assembly (C) so bead outlet is horizontally level with paint tip guard and as close to paint outlet as possible. Gun Kit Assembly 16R963 1. If needed, configure unit gun assembly with gun arm brackets included in Retro-fit Kit. C ti20548a 250 Models: ti20709a 200 Models: 5. Install 10 in. air line (G) and push into bottom valve.
Gun Kit Assembly 16R963 7. Push one end of remaining air line into top hole on air switch and run along bead hose to tank and then route and push into elbow fitting (J) on air tank. 8. Zip tie air and bead hoses together with supplied ties. 1 Gun: J ti20565a ti20980b ti20979b 250 Models 2 Gun: 200 Models 9. A “Y” fitting can be used to create a dual bead gun set up for double drop beads. Splice exit hose on bottom of air switch and branch into both guns. 10 in. 60 in. 60 in.
Gun Kit Assembly 16R963 0 to 8 in. Line Setup 2 Tank 1 Gun Setup For wider lines it may be necessary to mount bead gun as shown below. Connect “Y” fitting as shown below to allow two tanks to flow into one gun. ti20977a ti21085b Double Drop Setup ti20978b Use a “Y” fitting to create a dual bead gun setup for double drop beads. Splice exit hose on bottom of air switch and branch into both guns. 8 - 12 in.
Parts Parts 85 71 74 75 90 78 79 91 89 84 77 82 72 80 70 73 85 83 81 90 76 ti20722a 88 Parts List Ref. 70 71 72 73 74 75 76 77 78 79 80 Part 16T646 16T804 16T771 238329 16U274 16T829 16T816 16T803 104387 287566 111834 332226C Description SWITCH, air BRACKET, switch, air BOOT, button, push GUN, spray, bead HOSE, pneumatic HOSE, bead, 3/4 in., clear BRACKET, switch, air ARM, gun SCREW, mach pnh KIT, clamp NIPPLE, pipe, hex Qty . 1 1 1 1 1 1 1 1 2 1 1 Ref.
Graco Standard Warranty Graco warrants all equipment referenced in this document which is manufactured by Graco and bearing its name to be free from defects in material and workmanship on the date of sale to the original purchaser for use. With the exception of any special, extended, or limited warranty published by Graco, Graco will, for a period of twelve months from the date of sale, repair or replace any part of the equipment determined by Graco to be defective.
