User's Manual

Instructions

DynaStar

35#

Follower Plate

333029A

For use with 35# HP and HF Model DynaStar Pumps.

Part No.: 77X510

Parts

*For tube-in-tube installations only, the factory installed

grommet (186104) must be removed from the follower

plate and grommet (16V328), installed in it’s place. Dis-

card the unused grommet.

Important Safety Instructions

Read all warnings and instructions in this

manual and the DynaStar Pump Instruction

Manual. Save all instructions.

Ref.

No. Part No. Description Qty.

1 183241 WIPER 1

2 183245 SPRING, retaining 1

3 183242 PLATE, follower 1

4* 186104 GROMMET, follower,

non-tube-in-tube models (factory

installed)

16V328 GROMMET, follower, tube-in-tube

models (shipped loose)

5 103833 SCREW, machine; bnd-hd; 10-32 x

0.375 in. long

6 108714 PIN, clevis 1

7 220651 PLATE, wiper 1

PAGE 1
Instructions DynaStar® 35# Follower Plate 333029A EN For use with 35# HP and HF Model DynaStar Pumps. 4 Part No.: 77X510 5 Important Safety Instructions 3 Read all warnings and instructions in this manual and the DynaStar Pump Instruction Manual. Save all instructions. Parts Ref. No. 1 2 3 4* 2 Part No. 183241 183245 183242 186104 16V328 5 103833 6 7 108714 220651 Description Qty.
PAGE 2
Follower Plate Installation Instructions NOTE: Before the follower plate is installed, pack the cone with grease. 4. Press follower plate, cone side up, into a pail filled with grease and firmly press on it to remove all air pockets. 1. Relieve pressure using the Pressure Relief Procedure in your separate pump manual. 2. Remove pump. 3. Pack grease into follower plate cone (FIG. 1). FIG. 2 5.