User's Manual

Smart Control Operation

333388B Operation 27

Measure Mode

Measure Mode replaces a tape measure to measure

distances when laying out an area to be striped.

1. Use to select Measure Mode.

2. Press and release gun trigger control. Move striper

forwards or backwards. (Moving backwards is a neg-

ative distance.)

3. Press and release gun trigger control to end mea-

sured length. Up to six lengths are viewable.

NOTE: The most recent measured length is also saved

as the measured distance in the Stall Calculator display.

See Stall Calculator, page 29.

NOTE: Press and hold gun trigger control at any time to

apply a dot. If trigger is held while striper is moving, a

dot is marked every 12-inches (30.5cm).

Ref. Description

1 Hold to reset values to zero.

ti23825a

MEASURE MODE

I/O

....

0.00

....

ti18564b