User's Manual

Startup

18 3A0232R

Startup

1. Inspect o-rings on housings. Replace as needed.

See F

IG. 8.

2. Prime the system as required.

3. Align front head with housings and install front head.

Tighten front head locking ring (C).

4. Verify air cap retaining ring (D) is tight.

5. Verify fluid and air lines are at the desired pressures

then begin using the gun.

IG. 8

NOTICE

Gun damage can occur when the system is primed

with the front head installed. To avoid damage, only

prime the system with the front head removed.

Ensure locking ring (C) and retaining ring (D) are tight

before spraying. Spraying while either item is loose

may result in skin injection.

258840_3A0232_3g

Housing O-rings