User's Manual

Troubleshooting
28 3A0232R
No solvent Not enough solvent pressure Increase solvent pressure to the recommended
range of 80-100 psi (550-700 kPa, 5.5-7.0 bar).
No fluid in pressure pot Refill pressure pot
Output valve closed Open output valve
Check valve stuck closed Increase pressure in pressure pot
Material check valve plugged Clean and replace as needed
Solvent needle valve closed Open solvent needle valve
Solvent check valve stuck closed Ensure the solvent check valve opens freely
Solvent in cata-
lyst/resin mix
Solvent needle valve open Close solvent needle valve
Solvent check valve o-ring damaged or
missing
Inspect and replace if necessary
Solvent valve damaged Inspect and replace if necessary
Resin in solvent line Solvent needle valve open Close solvent needle valve
Solvent check valve o-ring damaged or
missing
Inspect and replace if necessary
Solvent valve damaged Inspect and replace if necessary
AAC does not shut
off
AAC needle o-ring damaged (internal mix) Inspect and replace if necessary
Atomized catalyst air
does not shut off
Atomized catalyst air needle o-ring dam-
aged (external mix)
Inspect and replace if necessary
Air leakage Air lines not fully seated in push lock tube
fittings
Ensure air lines are fully seated in fitting
Cutter assembly pivot tube o-ring damaged
or missing
Inspect and replace if necessary
AAC/Atomized catalyst external needle
o-ring damaged
Inspect and replace if necessary
Cutter air valve seat damaged Inspect and replace if necessary
G hook o-ring missing Inspect and replace if necessary
Cutter mount o-ring missing Inspect and replace if necessary
Problem Cause Solution