User's Manual

System Description
6 3A0294G
System Description
SmartWare shot dispense kits contain everything
needed to convert a supply system or a pump system
into a dosing system. The kits enable you to dose a pre-
set amount of single-component material without using
flowmeters or gear meters in the fluid stream. Instead, a
sensor tracks the pump position so that the pump acts
like a flowmeter. The amount dispensed is based on the
pump size.
Typical Applications
• Cartridge fill
• Potting
• Encapsulating
• Mold making
• Batching or kitting
Compatibility
SmartWare shot dispense kits are compatible with J
series NXT2200 and larger air motors, and D series
NXT1800 and smaller air motors.
Critical System Parameters
If any of the following parameters are below the recom-
mended value, see Appendix B - Tips, page 102, for
tips for better accuracy.
Percentage (shot size/pump size) -
Percentage (overshoot/shot size) -
(function of valve time and pump speed)
Air motor pressure (PSI) -
Pump Speed (CPM) -
< 20% > 100%
> 10%
< 3%
< 50 > 80
> 40 < 10