User's Manual

ManualsBrandsGraco ManualsAutomatic Lubrication SystemsGraco 3A0523C G3 Ouput Union Kit

Instructions

G3 Output Union

Kit

Used to join two or three pump outlets together. For professional use only.

Part No.: 571026 - 3 pump outlets, 571063 - 2 pump outlets.

Kit Parts

Important Safety Instructions

Read all warnings and instructions in this

manual and the G3 Pump Instruction manual

included with your unit. Save these instructions.

Ref. Description

571026

Qty

571063

Qty

1 TUBE, junction, rear 1 1

2 TUBE, junction, front 1 0

3 NUT, tube, 1/4 npt 4 2

4 FERRULE, tube, 1/4 4 2

5 FITTING, tube 4 2

6 BOLT, banjo (not shown) 2 2

7 BOLT, dual banjo bolt 1 0

8 WASHER, seal 7 4

9 FITTING, banjo, x 1/4 npt 4 2

10 PLUG, 1/4 npt w hex hd 4 1

3A0523C

Summary of content (4 pages)

PAGE 1
Instructions G3 Output Union Kit 3A0523C EN Used to join two or three pump outlets together. For professional use only. Part No.: 571026 - 3 pump outlets, 571063 - 2 pump outlets. Important Safety Instructions 1 Read all warnings and instructions in this manual and the G3 Pump Instruction manual included with your unit. Save these instructions. 8 9 7 4 2 5 10 3 Kit Parts Ref.
PAGE 2
Instructions Pressure Relief Instructions Kits 571063 - 2 pump outlets SKIN INJECTION HAZARD High-pressure fluid from dispense device, hose leaks, or ruptured components will pierce skin. This may look like just a cut, but it is a serious injury that can result in amputation. Get immediate surgical treatment. Follow Pressure Relief Procedure in this manual, when you stop dispensing and before cleaning, checking, or servicing equipment.
PAGE 3
Instructions left side of the G3 pump (b) (when viewed from the front) (FIG. 4). Kit 571026 - 3 Pump Outlets 1. Disconnect power to G3. 2. If unit has been in service, relieve pressure, page 2. c 3. Loosely assemble tube nut (3), tube ferrule (4) and tube fitting (5) (FIG. 2). 4. Apply thread sealant to threads of tube fittings (a) (FIG. 3). b 5. Connect one tube fitting assembly (3/4/5) to each banjo fitting (9). Wrench tighten (FIG. 3). 6.
PAGE 4
10. Install these two banjo assemblies in remaining open pump elements (b) and (d). 11. Install tube (1) (with 2 bends) around the back side of the G3 pump between the dual banjo fitting installed on the right side of the G3 pump and the banjo fitting installed on the left side of the G3 pump (viewed from the front) as shown in FIG. 9. 1 12.