User's Manual

Repair
16 3A0539L
9. Lubricate the throat packings and glands. Install the
spring (43) and one male gland (19†) in the throat
cartridge (40), then five v-packings with the lips fac-
ing down: one UHMWPE (20†), one leather (25†),
UHMWPE, leather, UHMWPE. Install the female
gland (26†). Install three v-packings with the lips
facing up: UHMWPE, leather, UHMWPE. Install the
other male gland (19†).
10. Lubricate the o-ring (42†) and install it on the
wet-cup (41). Install the wet-cup finger-tight.
11. Install the o-ring (35†) on the throat cartridge (40).
Apply lubricant to the throat cartridge threads then
screw the cartridge into the outlet housing (16)
loosely.
12. Install the outlet housing (16). It may not seat well
on the tubes and cylinder. Install the screws (13)
and lockwashers (14) from the inlet housing (15). As
you tighten the screws into the outlet housing (16),
they will draw the housings firmly onto the tubes and
cylinders. Tighten the screws uniformly and torque
to 25-30 ft-lb (34-40 N•m).
13. Torque the cartridge (40) to 95-100 ft-lb (129-135
N•m).
14. Torque the wet-cup (41) to 70-75 ft-lb (95-102 N•m).
15. Place a ball (23), seat (24) and gasket (7*) in each
side of the outlet manifold (22). Install the outlet
manifold on the outlet housing (16).
16. Apply removable (blue) Loctite
®
243 to entire length
of the screw (9) threads. Install the lockwashers (8)
and screws (9), and torque to 25-30 ft-lb (34-40
N•m).
NOTE: The outlet seats (24) are reversible.
17. Reassemble the spring (45), TSL pump piston seal
(46), and o-rings (47).
18. Reassemble the manifold and bottle assembly (48),
cap (49), collar (50) and screws (51). Torque the cap
(49) to 25-30 ft-lb (34-40 N•m).
19. Reinstall the coupling nut and collars on the piston
rod (17).
20. Fill the cavity in the bottom of the motor shaft with
grease. Reconnect the lower to the motor as
described in your separate pump manual.