User's Manual

ManualsBrandsGraco ManualsLine Striping EquipmentGraco 3A1585B - ThermoLazer Die Heat Retrofit Kit

Instructions

ThermoLazer

™

Die Heat Retrofit Kit

Model 24H620

- For professional application of thermoplastic traffic marking compound materials

(reflective beads applied simultaneously with screeding) -

- For outdoor use only (not to be operated in rain or damp conditions) -

IMPORTANT SAFETY INSTRUCTIONS

Read all warnings and instructions in

manual 3A1319. Save these instructions.

3A1585B

ti22971a

Summary of content (4 pages)

PAGE 1
Instructions ThermoLazer™ Die Heat Retrofit Kit Model 24H620 3A1585B EN - For professional application of thermoplastic traffic marking compound materials (reflective beads applied simultaneously with screeding) - For outdoor use only (not to be operated in rain or damp conditions) IMPORTANT SAFETY INSTRUCTIONS Read all warnings and instructions in manual 3A1319. Save these instructions.
PAGE 2
Installation 4. Apply sealant to male threads on tee. 1. Disconnect propane source. ti17138b 5. Assemble tee to regulator and orient as shown (18mm and 20mm). ti14128a ti17141b ti17144a 6. Apply sealant to torch hose threads. 2. Close valve by torch regulator. ti17140a ti14602a 7. Assemble torch hose to tee (15mm and 18mm). 3.
PAGE 3
8. Disassemble bead dispenser bracket bolts (19mm) from ThermoLazer. 11. Route hose as shown below. ti17145a 9. Slide die heat kit over bead dispenser. Align slot on bracket with bead dispenser screw head as shown. Bolt hole should also be aligned. ti17146a ti17148b 12. Attach hose swivel to tee fitting (21 mm). ti17147b 10. Assemble bead dispenser bracket bolts to unit. These bolts hold the die heat kit to the unit. 13.
PAGE 4
All written and visual data contained in this document reflects the latest product information available at the time of publication. Graco reserves the right to make changes at any time without notice. Original instructions. This manual contains English. MM 3A1585 Graco Headquarters: Minneapolis International Offices: Belgium, China, Japan, Korea GRACO INC. P.O. BOX 1441 MINNEAPOLIS, MN 55440-1441 Copyright 2008, Graco Inc. is registered to I.S. EN ISO 9001 www.graco.