User's Manual

Advanced Display Module (ADM) Operation
3A2175A 55
Advanced Display Module (ADM) Operation
When main power is turned on by turning the main
power switch (MP) to the ON position, the splash screen
will be displayed until communication and initialization is
complete.
To begin using the ADM, the machine must be on and
enabled. To verify the machine is enabled, verify the
System Status Indicator Light (CB) is illuminated green,
see F
IG. 7 on page 24. If the System Status Indicator
Light is not green, press the ADM Power On/Off (CA)
button . The System Status Indicator Light will illu-
minate yellow if the machine is disabled.
If the machine is in the Disabled mode screen press
repeatedly to select a different operating mode.
Perform the following tasks to fully setup your system.
1. Set general system settings. See Advanced
Screen 1, page 67.
2. Set units of measure. See Advanced Screen 2,
page 67.
3. Enable/disable system features. See Advanced
Screen 3, page 67.
4. Define control mode, dispense mode, and pump
information. See System Screen 1, page 61.
5. Define dispense valve and other system settings.
See System Screen 2, page 62.
6. Define labels and other system settings. See Sys-
tem Screen 3, page 63.
7. If L-Head is installed, define L-Head control
details. See Mix Head Operating Details Screen,
page 62.
8. Define level sensors and refill settings. See Supply
Screen, page 64.
9. If Night mode will be used, define Night mode set-
tings. See Conditioning Screen 3, page 66.
10. Calibrate machine. See Calibration Screen, Main,
page 60.
11. Define shots. See Shots Screen, page 59.
12. Define sequences. See Sequences Screen,
page 59.
13. If desired, view/reset counters. See Maintenance
Screen, page 64.