User's Manual

Appendix B - ADM Setup Screens Overview

66 3A2175A

Conditioning Screen 2

This screen shows the fluid path for the temperature

conditioning components and temperature setpoints for

each component.

NOTE: If tank blanket heaters or inline heaters are

installed along with hose heat, the hose heat setting will

be limited to at or below the inline or tank heat setting.

To edit the temperature setpoint and alarms for a partic-

ular component:

1. Press the Enter Screen button and navigate to the

component you wish to edit.

2. Press the enter key to display the setpoint and

alarm values associated with that component.

3. Edit the setpoint and alarm values and then press

the page back button to return to the previous

screen.

Conditioning Screen 3

This screen allows the user to configure Night Mode

operation. In Night Mode, the system will cycle on and

off periodically. Press the Enter Screen button and

adjust the on and off durations as desired.

When the system is in Night Mode and in an “On” cycle,

the system will circulate in low pressure. The installed

conditioning zones will be on and controlling to their

respective setpoints. When the system is in Night Mode

and in an “Off” cycle, the system will be idle. The system

will not be circulating, and the conditioning zones will not

be actively controlling temperature. When in Night

Mode, supply tanks will not fill.

NOTE: Gray fields on this screen are items unavailable

at this time. Future product releases will incorporate

these features.

OTE: All components are shown installed for refer-

nce only. Only 4 components can be installed at one

ime.